Custom Cutting Board Build Process



best sellersClick Here to see the latest specials at Amazon.


Custom Cutting Board Build Process
The process I use while making cutting/cheeseboards.

1) Joint and plane quarter-sawn wood
2) Rip down to width
3) Glue and clamp
4) Plane entire board
5) Cut to length on cross-cut sled
6) Round corners with bandsaw then belt sander
7) (not shown) Round over edges on router table
8) (not shown) Sand entire board
9) Mineral oil bath
10) Rub on 4:1 ratio of Mineral oil to Bees wax. Let it sit for a while then wipe off any excess

Related posts:

Leave a Reply

Your email address will not be published. Required fields are marked *